Table of Contents
Advertisement
Speedy 360
7.2.1
Space requirements
Ensure there is shielding or sufficient clearance to or from the wall and neighboring objects.
7.3
Setup
Observe the following steps:
1. Transport the machine to the installation location according to the specifications stated in the
chapter "Transport".
2. Make sure all the packaging material has been removed.
3. Remove any transport protections.
4. Install the two exhaust connectors at the rear of the machine. They have been removed for safety
reasons and for transport through doors.
5. The machine must stand upright.
6. Make sure the laser protection glass is intact.
7. Now connect the electrical components (see the following steps).
BA 8032_2.2_EN (05/2016)
www.troteclaser.com
54 / 90
Advertisement
Table of Contents
