Area Of Responsibility; Responsibilities Of The Operator - Trotec Speedy 360 flexx Operation Manual

Speedy 360
2.4

Area of responsibility

2.4.1

Responsibilities of the operator

- In addition to the safety notes and instructions stated in this manual, consider and observe
the local accident prevention regulations and general safety regulations that apply at the
operation site of the machine.
- If the machine is used industrially, the operator is subject to the legal obligations
concerning industrial safety.
- All personnel involved in installation, set-up, operation, maintenance and repair of the
machine must have read and understood this Operation Manual and in particular the
"Safety" section. The personnel must be trained and informed about all the functions and
potential dangers of the machine.
- The user is recommended to prepare company internal instructions considering the
occupational qualifications of the personnel employed in each case, and the receipt of the
instruction/Operation Manual or the participation in the introduction/training should in each
case be acknowledged in writing.
- Keep this manual in the immediate vicinity of the machine so that it is accessible at all
times to all persons working on or with the machine.
- Authority for the individual activities relating to the application of the machine (e.g.
installation, operation, maintenance and cleaning) must be clearly defined and observed,
so that no unclear competencies result under the aspect of safety. This applies in
particular to work to be performed on the electrical equipment that may only be performed
by qualified specialists.
- Maintenance and repair work as specified in the present operation manual must be carried
out regularly.
- For all activities concerning installation, set-up, start-up, operation, modifications of
conditions and methods of operation, maintenance, inspection and repair, the switch-off
procedures that may be provided in the Operation Manual must be observed.
- Provide appropriate personal protection equipment (e.g. protective goggles).
- The operator is responsible for the safety-related state of the machine.
- A CO fire extinguisher must always be at hand, as the laser beam can ignite flammable
2
materials.
- Do not store any flammable materials in the working area or in the immediate vicinity of
the device. Particularly, residues of processed materials have to be removed to prevent
any fire hazard.
- The operator must ensure cleanliness and accessibility at and around the machine by
corresponding instructions and controls.
BA 8032_2.2_EN (05/2016)
www.troteclaser.com
15 / 90