Plant Safety - Siemens SINAMICS G180 Installation And Operating Instructions Manual

Safety information

2.8 Plant safety

Note
Familiarize yourself with the local safety requirements and national safety guidelines and
always observe them.
2.8 Plant safety
Read the following information about safeguarding the equipment.
Unsecured installation site
This inverter is intended for use in industrial power installations and machines.
Accidents can occur if the equipment is not used for the intended purpose, is incorrectly
operated, is inadequately maintained or can be accessed by unauthorized persons. Death,
serious injury or material damage will result.
Secure the installation site against unauthorized access when using the inverter outside
industrial areas using suitable equipment (e.g. safety fences) and corresponding signage.
Install the inverter in a suitable area to which only properly trained personnel have access.
Procedure
You are responsible for the safety of the system.
You must ensure that the following requirements are fulfilled:
● Basic planning and all the work involved in transporting, assembling, installing,
commissioning, maintaining and repairing the equipment is only carried out by qualified
personnel or personnel supervised by responsible skilled technicians.
● The operating instructions and the complete product documentation are always available
when carrying out any work.
● The technical data and specifications regarding the permissible installation, connection,
environmental, and operating conditions are observed consistently.
● The system-specific installation and safety regulations are observed and measures are
taken to ensure personal safety.
● It is prohibited for unqualified persons to work on these devices or in their vicinity.
The product documentation, especially the operating instructions, and the notices on the unit
itself therefore contain only the information required by qualified personnel to use the
installations or machines for their intended purpose.
22
DANGER
Installation and Operating Instructions SINAMICS G180
Operating Instructions, 02/2019, 4BS0751-007