Operation According To "Namur 4 - Siemens SINAMICS G180 Installation And Operating Instructions Manual

Operation
8.3 NAMUR mode settings
8.3.5

Operation according to "NAMUR 4"

(D)
(S)
Figure 8-10
Operation different from "NAMUR 3"
The operation "Speed On" for "normal" mode is dynamic.
● Start the drive with a normally open contact at -X2:10.
● Issue the command "Speed Off" with an NC contact at -X2:11.
142
Dynamic: Pushbutton mode
Static: Switch mode
Assignment of the control cable terminals for "NAMUR 4" mode
Installation and Operating Instructions SINAMICS G180
Operating Instructions, 02/2019, 4BS0751-007