Configuring Operating Sources; Invoking Mode Configurations - Siemens SINAMICS G180 Installation And Operating Instructions Manual

Operation
8.1 Operation
8.1.7

Configuring operating sources

● Assign the functions mentioned above to the desired operating source.
– You can configure operating sources for "Local", using internal display, "Remote",
● Configure your selection for the On/Off commands with the command "Op.-source" in the
menu "P-INTERFACE\Op.-source" .
● If you wish to switch between "Local" and "Remote", then invoke the changeover using a
finished configuration under "P-OPERATION/Opr." or change the setting "P-
PARAMETER SWITCH".
● Select the Reset source for the Reset command under "P-INTERFACE" .
– If you would like to activate the reset independently of the operating source
8.1.8

Invoking mode configurations

Invoke the finished operating configurations under "P-OPERATION/Opr.". Settings for the
controls and the parameter switches are automatically made in these configurations.
For each selection, there is an associated connection plan and a specified mode of
functioning of the display buttons and digital inputs. Further information can be found in the
"Standard mode settings" (Page 135) section.
Changes in the menu "P-OPERATION/" cause under "P-OPERATION/Opr." the addition
"special" as information that something has been changed from the standard.
128
using control cable terminal block -X2 and "BUS".
changeover, then set "Global". The reset is then possible at all operating sources.
Installation and Operating Instructions SINAMICS G180
Operating Instructions, 02/2019, 4BS0751-007