Siemens SINAMICS G180 Installation And Operating Instructions Manual page 204

Technical data
C.7 Technical data of the control cable terminals
Technical data of the control cable terminals
Conductor cross-section –X2
Relay outputs -X2:30 ... 42
With peripheral board 3 or 4 only:
Relay outputs -X2:43 ... 49
Digital inputs -X2:8 ... 16
Digital input safe torque off (only
with peripheral board 3 or 4):
-X2:20
Analog inputs -X2:50 ... 53
Supply voltages on potential of the
analog inputs for diverse sensors:
Digital inputs –X2:27, 28
Digital input -X2:29
Analog outputs -X2:60 ... 63
Supply voltages on potential of the
analog outputs:
0 mA or 4 mA can be parameterized.
*)
202
rigid / flexible: 0.5 mm² ... 2.5 mm²
5 V ... 250 V AC / 1 A, 15 AC
5 V ... 30 V DC / 1 A
> 30 V ... 60 V DC / 120 mA
> 60 V ... 250 V DC / 60 mA
Minimum switching load: 12 V / 100 mA
Low: -3 V ... +5 V
High: 13 V ... 32 V
Floating
Typically 12 mA for High
Low: -3 V ... +5 V
High: 13 V ... 32 V
Floating
Typically 12 mA for High
Response time: ≤ 5 ms
Voltage input 0 V ... ± 10 V, 200 kΩ
Terminal 52 and 54 or current input
0 mA or 4 mA ... ± 20 mA, 100 Ω,
*)
Terminals 50 and 53
Terminal 55: 24 V DC, max. 300 mA
Terminal 56: 15 V DC, max. 150 mA
Terminal 57: 10 V DC, max. 10 mA
Terminal 58: -10 V DC, max. 10 mA
Low: -3 V ... +5 V
High: 13 V ... 32 V
Floating on potential of the analog inputs
Typically 2.4 mA for High
Direct connection of PTC thermistors
Reference potential for PTC thermistor:
Terminal -X2:58 (-10 V).
The voltage over the PTC thermistor is approx. 2.5 V
Can also be used as f or n input.
Low: -3 V ... +5 V, high: 13 V ... 32 V
Floating on potential of the analog inputs, typically 2.4 mA for High
Can also be used as f or n input
With automatic changeover current or voltage, floating:
Load < 300 Ω: 0 mA or 4 mA
Load > 1 kΩ: 0 V ... 10 V
Terminal 70: 24 V DC, max. 300 mA
... 20 mA
*)
Installation and Operating Instructions SINAMICS G180
Operating Instructions, 02/2019, 4BS0751-007