Controlling The External Connections Of The Inverter; Function Of The Control Cable Terminals; Protective Separation According To En 61800-5-1 - Siemens SINAMICS G180 Installation And Operating Instructions Manual

8.4

Controlling the external connections of the inverter

8.4.1

Function of the control cable terminals

Figure 8-13
The purpose of the control cable terminals is to connect control cables for exchanging
signals.
For more detailed information about the function of control cable terminals, refer to section
"Standard mode settings" (Page 135). The function of the control cable terminals, with the
exception of input -X2:8 for hardware shutdown, is dependent on the parameterization.
8.4.2

Protective separation according to EN 61800-5-1

High voltages
If you connect peripheral devices which do not conform to this insulation concept,
equipment damage might occur as a result of inadequate insulation. This can result in
death, serious injury or material damage.
Connect devices and cables to the control cable terminals only if they conform to the
relevant voltage class (DVC) described in this section.
Installation and Operating Instructions SINAMICS G180
Operating Instructions, 02/2019, 4BS0751-007
Control cable terminals
WARNING
8.4 Controlling the external connections of the inverter
Operation
145