Protective Cover Ip21 For Compact And Compact Plus Devices - Siemens SINAMICS G180 Installation And Operating Instructions Manual

5.3

Protective cover IP21 for compact and compact Plus devices

Figure 5-1
All compact units have degree of protection IP20. The canopy with degree of protection IP21
is available as an accessory for all compact and compact Plus devices. The cover is 5 mm
wider on both sides than the inverter.. Take account of this clearance for the alignment.
Leave the outlet area at the front clear.
Proceed as follows to install the roof supplied loose:
1. Screw the inverter without cover on to a mounting plate. Do not tighten the top two
mounting screws completely.
2. Slide the cover under the not yet completely tightened mounting screws.
3. Tighten the mounting screws completely.
With degree of protection IP21, the type code changes from 2T2A.....-... to 2T3A.....-... .
Installation and Operating Instructions SINAMICS G180
Operating Instructions, 02/2019, 4BS0751-007
5.3 Protective cover IP21 for compact and compact Plus devices
Canopy IP21
Installation
85