Editing A New Nc Program - Siemens SINUMERIK 840C Operator's Manual

6 Programming
6.3.3

Editing a new NC program

S et
block num ber
Example
Note
E dit
Generate
block number
© Siemens AG 1999 All Rights Reserved
SINUMERIK 840C, OEM Version for Windows (BA)
A presetting can be made before editing the program.
Softkey SET BLOCK NUMBER is used to preset block number generation.
The following display appears when you press this softkey:
Fig. 6-32 Block number setting
The values are entered via the keyboard with INPUT.
The presetting is "5"; i.e. the first block number is N5, the next N10 etc.
N5 .... L F
N10 .... L F
N15 .... L F
A maximum of 4 numbers can be input.
The block settings made here are also effective in TEACH IN mode.
This calls the program.
Press this softkey to generate a block number. The block number is inserted at
the cursor position according to the presetting.
Enter the program blocks using the alphanumerical keypad.
6FC5198-6AA60-0BP1
01.99
6-51