Siemens SINUMERIK 840C Operator's Manual page 237

01.99
Note
G enerate
block num ber
Save
to disk
Save
un der
Notes
6-52
You can enter spaces between the words (G, H, M... commands) for clarity.
These spaces are not required. The NCK processes the program blocks even if
no spaces are entered.
Press the INPUT key to terminate the program block. An end of block
character (L F ) is automatically created.
If you press the GENERATE BLOCK NUMBER softkey again, the system
adds the block number difference to the block number and inserts the result at
the cursor position.
The softkey SAVE TO DISK and
the softkey SAVE UNDER are used to save the edited program on the hard
disk.
• The program entered must be completed with end of program (M30, M17,
M02).
• Programming is described in more detail in the Programming Guide.
• In the PROGRAMM./EDIT NC area you can create a program
− via the keyboard and/or
− with the help of the operator support function
− (you can also work alternately with keyboard or operator support)
Important
The part program memory has no battery backup. If an NC program is edited
in the part program memory and is to be retained in the control after it has
been switched off, this program must be transferred onto the hard disk.
Note
The workpiece STANDARD is set up in the workpiece directory LOCAL by
the operating system. It is automatically loaded into the NCK memory on
powering up the control. In STANDARD you can store part programs or NCK
data.
Machine manufacturer
The machine manufacturer can specify via machine data whether the
workpiece last active is to be loaded again. Precondition therefore is that a
workpiece was loaded before switching off the control.
6FC5198-6AA60-0BP1 © Siemens AG 1999 All Rights Reserved
SINUMERIK 840C, OEM Version for Windows (BA)
6 Programming