Siemens SINUMERIK 840C Operator's Manual page 246

6 Programming
Operating
sequence
LF
%
D elete
*
Delete
?
6
D elete
Note
© Siemens AG 1999 All Rights Reserved
SINUMERIK 840C, OEM Version for Windows (BA)
Deleting by entering the program number
The program with the number entered is deleted by the control.
or
all of the programs with identifiers before the "*" are deleted
e.g. MPF1*
If you enter MPF* or SPF* all of the main programs or subroutines are deleted.
or
you can use the question mark to represent an individual character in the
program name.
e.g. MPF?
All of the main programs with a single-digit program number are deleted, i.e.
MPF0 to MPF9
MPF2??
The programs MPF 200 to 299 are deleted.
You can also delete areas of a program by entering the start and end of the area
and pressing the delete softkey. For example, if you enter
%700 %710 or
%700=%710
all of the main programs between %700 and %710 are deleted.
Note
Cycles must be enabled before deletion.
As long as a part program has been selected in the editor (EDIT NC), it cannot
be deleted. First of all, the editor must be closed or the program must be
enabled for deletion by selecting another program.
6FC5198-6AA60-0BP1
01.99
6-61