Description Of Individual Functions, Dry, M01, Rov, Acr, Drf, Dsb, Pst, Brk, Clr, Ext, Ncy, Sav, Skp, And Predec. Blocks - Siemens SINUMERIK 840C Operator's Manual

01.99
4.3.4.1 Description of individual functions, DRY, M01, ROV, ACR, DRF, DSB,
PST, BRK, CLR, EXT, NCY, SAV, SKP, and predec. blocks
DRY
M01
ROV
ACR
© Siemens AG 1999 All Rights Reserved
SINUMERIK 840C, OEM Version for Windows (BA)
Use the window switchover key to switch to the "Program modification"
screenform. The active window is marked (by a yellow frame).
With the cursor keys you select the program modification function. A cursor
marks the current position.
Each function can be selected or deselected via an associated toggle field by
means of yes/no.
All active functions are displayed in the status field with the corresponding
abbreviation (SKP, DRY, M01, ROV, DSB, DRF, ACR, PST, BRK, CLR or
EXT). The SINGLE BLOCK function acts mode group-specific. All other
functions act channel-specific. They remain active until they are deselected or
until the control is switched off.
This machine function can be used to set the following parameters and thus
modify program execution correspondingly:
Dry run feedrate; Display: DRY (DRY RUN):
All those blocks in which a feedrate is programmed (GO1, G02, G03, G33,
G34, G35), are traversed at the "Dry run feedrate" preset by a setting data
instead of at the programmed feedrate. The dry run feedrate then also applies in
place of the "revolutional feedrate" G95 and the feedrate for thread cutting.
Programmed stop; Display M01 (M function):
If an "M01" is present in the part program, the program is stopped. If the
function is marked "NO" the "M01" is ignored.
Rapid override; Display: ROV (RAPID TRAVERSE OVERRIDE).
If "NO" is set, the feedrate/rapid override switch is only active for "Feedrate".
If the softkey function is set to "YES", the override set at this override switch is
also active for rapid traverse.
Axis converter; Display: ACR (Axis Converter)
ACR is an optional function to convert existing axis addresses in a part
program in other axis addresses. A screenform is available in the
PARAMETER/SETTING DATA area for entering the names.
6FC5198-6AA60-0BP1
4 Machine
4-63