Serial Communications Connection Procedure; Work Flow - Omron E5*D Series Connection Manual

7.

Serial Communications Connection Procedure

This section describes the procedures for connecting the Controller to the Digital Temperature
Controller via serial communications. The procedures for setting up the Controller and the
Digital Temperature Controller in this guide are based on the factory default settings.
For the initialization, refer to Section 8. Initialization Method.
7.1.

Work Flow

Take the following steps to connect the Controller and the Digital Temperature Controller via
serial communications and to send or receive a message.
7.2. Digital Temperature Controller
Setup
↓
7.2.1. Parameter Settings
↓
7.3. Controller Setup
↓
7.3.1. Hardware Settings
↓
7.3.2. Starting Sysmac Studio and
Importing the Project File
↓
7.3.3. Checking the Parameters and
Building Programs
↓
7.3.4. Going Online and Transferring
the Project Data
↓
7.3.5. Transferring the Unit Settings
↓
7.4. Serial Communication Status
Check
↓
7.4.1. Checking Received Data
7．Serial Communications Connection Procedure
Set up the Digital Temperature Controller.
Set parameters for the Digital Temperature
Controller.
Set up the Controller.
Set the hardware switches on the Serial
Communications Unit and connect the cables.
Start Sysmac Studio and import the project file.
Check the parameters of the Serial
Communications Unit, execute the program check
on the project data, and build the project programs.
Go online with Sysmac Studio and transfer the
project data to the Controller.
Transfer the setting data of the Serial
Communications Unit.
Start the send/receive processing and confirm that
serial communications performs normally.
Check that correct data is written to the variables of
the Controller in Sysmac Studio.
10