Device Configuration - Omron E5*D Series Connection Manual

5.2.

Device Configuration

The hardware components to reproduce the connection procedures in this guide are as
follows:
Personal computer
(Sysmac Studio installed,
OS: Windows 7)
USB cable
Manufacturer
OMRON Serial Communications Unit
OMRON NJ-series CPU Unit
OMRON Power Supply Unit
OMRON Sysmac Studio
OMRON Sysmac Studio project file
- Personal computer
(OS: Windows 7)
- USB cable
(USB 2.0 type B connector)
- Serial cable (RS-485)
OMRON Digital Temperature Controller
Precautions for Correct Use
Prepare the project file with a latest version beforehand.
To obtain the project file, contact your OMRON representative.
Precautions for Correct Use
Update Sysmac Studio to the version specified in this Clause 5.2. or to a higher version.
If you use a version higher than the one specified, the procedures and related screenshots
described in Section 7. and the subsequent sections may not be applicable.
In that case, use the equivalent procedures described in this guide by referring to the Sysmac
Studio Version 1 Operation Manual (Cat. No. W504).
Precautions for Correct Use
Turn ON the terminating resistance switch on the Serial Communications Unit and connect
120 Ω (1/2 W) terminating resistance to the terminals of the Digital Temperature Controller at
either end of the RS-422A/485 transmission path.
5．Applicable Devices and Device Configuration
NJ501-1500＋
CJ1W-SCU42
Name
CJ1W-SCU42
NJ501-1500
NJ-PA3001
SYSMAC-SE2□□□
P520_NJ_CWF485_OMRON_E
5CD_V100.csm2
-
-
-
E5CD -RX2A6M-002
E5CD-RX2A6M-002
Serial cable
(RS-485)
Model Version
Ver.2.0
Ver.1.16
Ver.1.21
Ver.1.00
6