Omron E5*D Series Connection Manual page 23

4
Parameter group to show is set
to Port1: Serial Gateway
Settings.
The setting items of Port1: Serial
Gateway Settings are shown.
Check that Port1: Port settings
is set to User settings and that
the other settings are the same
as those listed in 6.1.
Parameters.
*If the setting values are
different, select the values from
the pull-down list. After
changing the values, click
Apply.
5
Double-click I/O Map under
Configurations and Setup in
the Multiview Explorer.
The I/O Map Tab Page is
displayed, and then the
parameters of Serial
Communications Unit are listed.
6
Check that the variable names
in the Variable Column start with
J01 and that "Global Variables"
is set for each of them in the
Variable Type Column.
*If the settings are different from
the above, right-click
CJ1W-SCU42 and select
Create Device Variable.
7．Serial Communications Connection Procedure
20