Error Processing - Omron E5*D Series Connection Manual

9.7.

Error Processing

The errors that may occur during the program execution are shown below.
9.7.1. SendCmd Instruction Error
These error codes are generated when the SendCmd instruction ends in error.
●SendCmd instruction error code [Output_CmdErrorID, Output_CmdErrorIDEx]
An error code of ErrorID is stored in Output_CmdsErrorID, and an error code of ErrorIDEx is
stored in Output_CmdsErrorIDEx.
[Output_CmdErrorID]
Value
16#0400 An input parameter for an instruction exceeded the valid range for an input
variable.
16#0406 The data position specified for an instruction exceeded the data area range.
16#0407 The results of instruction processing exceeded the data area range of the
output parameter.
16#0800 An error occurred when a FINS command was sent or received.
Detailed information is stored in Output_CmdErrorIDEx.
16#0801 The port is being used.
Additional Information
For details on errors, refer to A-3 Error Code Details of the NJ/NX-series Instructions
Reference Manual (Cat. No. W502).
For information on troubleshooting, refer to 9-3 Troubleshooting of the CJ-series Serial
Communications Units Operation Manual for NJ-series CPU Unit (Cat. No. W494).
[Output_CmdErrorIDEx]
For information on error codes to be stored, refer to the list of expansion error code
ErrorIDEx described in SendCmd in Section 2. Instruction Descriptions of the NJ/NX-series
Instructions Reference Manual (Cat. No. W502).
Error description
9．Program
52