Notes On Installing Into The Rack - Fujitsu PRIMERGY RX800 S2 Operating Manual

Important Notes
2.5

Notes on Installing into the Rack

V
CAUTION!
For safety reasons, at least two people are required to install the
rack model because of its weight and size.
Never lift the server into the rack using the handles on the front panel.
When connecting and disconnecting cables, observe the relevant
notes in the chapter "Important notes" in the technical manual for the
corresponding rack. The technical manual is supplied with the corre-
sponding rack.
Ensure that the anti-tilt bracket is correctly mounted when you set up
the rack.
For safety reasons only one unit may be withdrawn from the rack at a
time when performing assembly or service work.
If more than one unit is withdrawn from the rack at any one time, there
is a danger that the rack will tilt forward.
The power connection for the rack must be installed by an authorized
technician (electrician).
If the rack model is integrated in an installation that receives power
from an industrial (public) power supply network with the IEC309
connector, the (public) power supply protection must comply with the
requirements for the non-industrial (public) power supply networks for
the type A connector.
U41621-J-Z156-1-76
Notes on Installing into the Rack
25