Table of Contents
Advertisement
Preparation for Operation
Enabling and configuring SOL using the OSA SMBridge management
utility program
To enable and configure the server for SOL by using the OSA SMBridge
management utility program, you must update and configure the BIOS code and
enable the operating system for an SOL connection.
In an SOL session, use the following commands instead of function keys:
i
Ê To start the Configuration/Setup Utility program when the prompt
Press F1 for Configuration/Setup appears, press [ESC],
Shift+o, then Shift+p.
Ê To start the diagnostic programs, when the prompt F2 for
Diagnostics appears, press [ESC], Shift+o, then Shift+q.
Updating and configuring the BIOS
Ê Update the BIOS code:
Ê Download the latest version of the BIOS code from
http://www.fujitsu-siemens.com/support/.
Ê Update the BIOS code, following the instructions that come with the
update file that you downloaded.
Ê Configure the BIOS settings:
Ê Restart the server and press F1 when prompted to start the Configu-
ration/Setup Utility program.
Ê Select Devices and I/O Ports; then, make sure that the values are set as
follows:
Serial Port A: Auto-configure
Serial Port B: Auto-configure
Ê Select Remote Console Redirection; then, make sure that the values are
set as follows:
Remote Console Active: Enabled
Remote Console COM Port: COM 2
Remote Console Baud Rate: 19200
Remote Console Data Bits: 8
Remote Console Parity: None
U41621-J-Z156-1-76
Configuring the Server
73
Advertisement
Table of Contents
