Configuring the Server
4.3.6
Using the SAS Configuration Utility program
Use the SAS Configuration Utility program to configure SAS devices. This
program is described in more detail in the ServeRAID-8i user manual.
Starting the SAS Configuration Utility program
To start the SAS Configuration Utility program, complete the following steps:
Ê Turn on the server.
Ê When the prompt <<< Press <CTRL><A> for Adaptec SAS/SATA
Configuration Utility! >>> appears, press Ctrl+A.
Ê To select a choice from the menu, use the arrow keys.
Ê Follow the instructions on the screen to change the SerialSelect Utility or
Disk Utilities settings.
SerialSelect Utility menu choices
The following choices are on the SerialSelect Utility menu:
SAS Controller Configuration
Select this choice to view or change SAS controller settings. To reset the
controller to its default settings, press [F6] and follow the instructions on the
screen.
PHY Configuration
Select this choice to view or change PHY configuration settings. To reset the
controller to its default settings, press [F6] and follow the instructions on the
screen.
Disk Utilities
Select this choice to format, verify, or locate SAS devices. Select a device from
the list and read the instructions on the screen carefully before making a
selection.
4.3.7
Configuring the RSA-II
For information about setting up and cabling the RSA-II, see the RSA-II user
manual (see "Related Publications" on page 133).
66
Preparation for Operation
U41621-J-Z156-1-76