Table of Contents
Advertisement
Configuring the Server
Remote Console Stop Bits: 1
Remote Console Text Emulation: ANSI
Remote Console Keyboard Emulation: ANSI
Remote Console Active After Boot: Enabled
Remote Console Flow Control: Hardware
Ê Press [ESC] twice to exit the Remote Console Redirection and Devices
and I/O Ports sections of the Configuration/Setup Utility program.
Do not use Planar Ethernet 1 for PXE/DHCP booting or instal-
i
lation.
Ê Select Start Options; then, set Planar Ethernet PXE/DHCP to one of the
following settings:
Disabled
Planar Ethernet 2. If you set Planar Ethernet PXE/DHCP to Planar
Ethernet 2, you must also set Run PXE only on selected Planar NIC to
Enabled.
Ê Press [ESC] to exit the Start Options section of the Configuration/Setup
Utility program.
Ê Select Save Settings; then, press [Enter]
Ê Press [Enter] to confirm.
Ê Select Exit Setup; then, press [Enter] .
Ê Make sure that Yes, exit the Setup Utility is selected; then, press [Enter].
Configuring Linux
For SOL operation on the server, you must configure the Linux operating system
to expose the Linux initialization (booting) process. This enables users to log in
to the Linux console through an SOL session and directs Linux output to the
serial console. See the documentation for your specific Linux operating-system
type for information and instructions.
Use one of the following procedures to enable SOL sessions for your Linux
operating system. You must be logged in as a root user to perform these proce-
dures.
Configuring Red Hat Enterprise Linux ES 2.1:
74
Preparation for Operation
U41621-J-Z156-1-76
Advertisement
Table of Contents
