1St Bimschv - TESTO 300 LL NEXT LEVEL Instruction Manual

9 Performing the measurement

1st BImSchV

9.5.3
Do not operate the product if there are signs of damage on the
•
housing, mains unit or connected cables.
The product must be checked for any visible damage before
•
commissioning.
Do not store any solvents (e.g. isopropanol) or items containing
•
solvents in the case, as the vapours can damage the sensors.
In the case of the 1st BImSchV, the Smart Probe testo 915i (0563
3915) can be connected allowing the combustion air temperature to be
measured in parallel.
The measuring instrument has been tested according to the requirements of
•
VDI 4206 part 1.
The following fuels are approved for measurements according to the 1st
•
BImSchV:
Fuel CO
Natural
gas
Fuel oil
EL
LPG
Town gas
Briquettes
Lignite
Hard coal
Wood 15%w
Wood
pellets
For official measurements in accordance with the first German Federal
•
Immission Control Ordinance (BImSchV), the measuring instrument must be
checked every six months by a technical testing body of the Guild of Master
Chimney Sweeps or another testing body recognised by the authorities.
To achieve usable measurement results, the measurement period for
flue gas should be approx. 3 minutes and the measuring instrument
should display stable measured values. Readiness for operation is
achieved after a maximum of 10 minutes.
60
[vol.%] O
2max 2base
11.9 3.0
15.4 3.0
13.7 3.0
13.6 3.0
18.9 8.0
19.8 8.0
20.5 8.0
20.3 13.0
20.3 13.0
[%] V V
AG Lmin
trmin
8.36 9.12
10.53 11.26
23.80 25.95
3.61 3.90
5.08 5.20
4.01 4.09
7.81 7.82
3.87 3.93
4.07 4.13
A2 B
0.6600 0.0090
0.6800 0.0070
0.6300 0.0080
0.6300 0.0110
0.8330 0.0000
0.9550 0.0000
0.7580 0.0000
0.6860 0.0096
0.6200 0.0081