Bimschv (Testo 330-2 Lx) - TESTO 330 LX Instruction Manual

6.2.5.

BImSchV (testo 330-2 LX)

A qA mean value measurement can be carried out. For this
purpose the mean value is determined continuously over a period
of 30s, the measuring cycle takes 1s. The mean values actually
valid at the corresponding time of recording are displayed.
Calling up the function:
✓ A flue gas probe and a combustion air temperature probe must
be connected.
> [
> Select the fuel → [OK].
Performing the measurement:
1. Start the measurement series:
2. Position the flue gas probe in the centre of flow (area of the
highest flue gas temperature). The graphical representation of
the maximum measured flue gas temperature (red line) helps
when positioning the flue gas probe.
> Option
Start draught measurement:
3. [Next].
- The qA readings (O
determined (30s).
> > Option
Cancel draught measurement:
- The measurement stops automatically.
- The readings are automatically displayed and saved in a record.
4. Quit measurement: [Close].
Options:
> [Options]
> [Options]
is deleted.
> [Options]
form of a line graph.
> [Options]
parameters to be represented (max. 4) can be displayed (
hidden (
] → Measurements
Wait for the balancing time, until O
20 %.
, AT, VT) and the draught value are
2
→ Clipboard: Data are saved to the clipboard:
→ Delete
→ Show Graphic: The readings are displayed in
→ Configure
).
→ [OK] → BImSchV
[ ]
2
[Drgt start]
[Drgt stop]
clipboard: Any data saved to the clipboard
Graphic: The measurement
6 Using the product
→ [OK].
shows a value below
) or
55