Identification Data For Objects In The User Area; Overview Of Maintenance; Introduction And Status Diagram - Siemens Simatic PCS7 Function Manual

6.12.6

Identification data for objects in the user area

Where does the identification data for objects in the user area come from?
In the case of the faceplate for objects in the user area that are integrated using a device
description (EDD), the identification data is provided via SIMATIC PDM.
The following table shows the assignment of the identification data displayed on the MS to the
origin.
Identification
data
TAG / HID
LID
Address
Description
Message
Device type
Manufacturer
Article number
1)
Serial number
Installation
date
HW revision
SW revision
Last update
Comment
Article number = also order number or MLFB
1)
6.13

Overview of maintenance

6.13.1

Introduction and status diagram

Introduction
The operators of the Maintenance Station and the Operator Station can be different individuals
and can work in physically separate locations.
As a result, the information flow between the Maintenance Station and Operator Station is not
guaranteed.
Maintenance takes place in agreement with the plant operator.
Communication is supported by means of icons and messages.
Maintenance Station
Function Manual, 03/2016, A5E36187641-AA
Origin
Parameter "TAG"
Parameter "Installation location"
Not available
Parameter "Description"
Parameter "Message"
Parameter "Product name"
Parameter "Manufacturer"
"Article number" parameter
Parameter "Device serial number"
Parameter "Installation date"
Parameter "Hardware revision"
Parameter "Software revision"
Time stamp of the updating of the PDM database
CFC "Block comment"
Operator control and monitoring
6.13 Overview of maintenance
1)
189