Origin Of The Identification Data; Identification Data For Ipcs - Siemens Simatic PCS7 Function Manual

Additional information
You can find information on the redundancy state in the section "Maintenance status of
redundant components (Page 126)".
6.12

Origin of the identification data

6.12.1

Identification data for IPCs

Where does the identification data for IPCs come from?
In the case of the faceplate for IPC objects, the identification data is read from the device via
an SNMP connection.
The device must be configured in the SNMP OPC Server of the maintenance station for this.
These data are prepared for display on the maintenance station with the "Export tags for
WinCC" function.
The following table shows the assignment of the identification data displayed on the MS to the
origin.
Identification data
TAG / HID
LID
Address
Description
Message
Device type
Manufacturer
Article number
Serial number
Installation date
HW revision
SW revision
Last update
Comment
Article number = also order number or MLFB
1)
Maintenance Station
Function Manual, 03/2016, A5E36187641-AA
Origin
SNMP Profile V1.5 for IPC
SNMP tag ".sysName"
Object properties of the PC station "Name"
HW Config/OPC server "IP address" /
SNMP tag "&ipAddress()"
Not available
SNMP tag ".ProductName"
SNMP tag ".Manufacturer"
SNMP tag ".StationMLFB"
1)
SNMP tag ".StationSerialNumber"
Not available
SNMP tag ".HwVersion"
SNMP tag ".SwVersion"
Time stamp of the updating of the identification data
Object properties of the PC station "Comment"
Operator control and monitoring
6.12 Origin of the identification data
PC with support of the SNMP
Profile MIB-II
Not available
IP address terminal bus
CCAgent
Not available
Not available
Not available
Not available
Not available
Not available
183