Required Tools; Torque Values Of The Screw Connections - Otto Bock C1000 SF Instructions For Use Manual

Table of Contents

Driving data

Transport and storage temperature

* The controller and the motors have to be protected against overloading. Therefore, the continuous climbing ability depends

on the overall weight (wheelchair weight + user weight + payload) as well as the ground conditions, exterior temperature,

battery voltage and driving style of the user. In individual cases, the continuous climbing ability can be significantly lower

than the value specified.

** The specified range was determined under defined conditions in accordance with ISO 7176-4. In practice the range can

be reduced by up to 50%. For information on this, see the section "Range" in the instructions for use (user).

*** The braking distance can be longer accordingly due to the user weight, installed options and condition of the tyres, as

well as due to weather conditions and the surface.

Corrosion protection

11.2 Required Tools

The following tools are required for adjustments and maintenance work:

•

Allen wrenches in sizes 3, 4, 5, 6

•

Ring and open-ended wrenches in sizes 10, 11, 13, 19 and 24

•

Torque wrench (measurement range 5-50 Nm)

Unless otherwise specified, screw connections are tightened with the following torque values:

•

Thread diameter M4: 3 Nm

•

Thread diameter M5: 5 Nm

•

Thread diameter M6: 10 Nm

•

Thread diameter M8: 25 Nm

C1000 SF

-15 °C to +40 °C

Coated frame

Appendices

Ottobock | 33

Table of Contents