Handing Over The Product; Maintenance And Repair - Otto Bock C1000 SF Instructions For Use Manual

Fig. 16 Eyebolts, rear

7.3 Handing over the product

WARNING
Lack of instruction
Tipping over, falling of the user due to lack of knowledge
► Instruct the user or the attendant in the proper use of
the product when handing it over.
The following steps must be performed for the safe han­
dover of the product:
• Have the user get into the product and perform a trial
seat fitting. Pay special attention to proper positioning
according to medical considerations.
C1000 SF
• The user and any attendants must be instructed in the
safe use of the product. In particular, the enclosed
instructions for use (user) are to be used.
• The instructions for use (user) must be issued to the
user or an attendant during handover of the wheelchair.
• The user or attendant should acknowledge that they
have been instructed in how to use the product and
were informed of the residual risks.
• The user and all attendants definitely need to be advised
that, when the power wheelchair is used in vehicles for
transporting persons with reduced mobility, the buckle
tongues of the seat retaining straps must be connected
to the buckles at the back of the seat.

8 Maintenance and repair

The manufacturer recommends regular maintenance of the
product every 12 months.
The instructions for use (user) contain further information on
cleaning/disinfection as well as maintenance/repair by the
user.
Detailed information
ming/troubleshooting of the control unit can be found in the
service manual.
Maintenance and repair
on repairs and program­
Ottobock | 27