Settings - Otto Bock C1000 SF Instructions For Use Manual

Settings

• The power wheelchair control unit must be switched off
while the batteries are charging to allow all of the char­
ging current to be fed into the battery.
6 Settings
6.1 Prerequisites
WARNING
Incorrect settings
Risk of falling, tipping over or improper user posture due to
incorrect settings
► Adjustments may only be carried out by qualified per­
sonnel instructed by the manufacturer.
► Check for safe function before delivering the product.
CAUTION
Unsecured screw connections
Pinching, crushing, tipping over, falling of user due to
assembly errors
► After all adjusting/readjusting work, retighten the
mounting screws/nuts firmly. Observe any torque set­
tings which may be specified.
► Any time you loosen a screw connection with thread
lock, replace it with a new screw connection with
thread lock or secure the old screw connection with
medium strength thread locker (e.g. Loctite
16 | Ottobock
Fine fitting/adjusting work should always be performed with
the user. The user should sit upright in the power wheel­
chair while adjustments are made.
All parts of the product should be cleaned thoroughly before
adjustments are made.
The tools required for adjustments and maintenance tasks
as well as the torque values for screw connections are listed
in the section "Appendices" (see Page 30 ff.).
6.2 Basic settings
The following fitting tasks are described in more detail in the
included Instructions for use (user):
• Adjusting the belt length
• Adjusting the control panel
• Adjusting the luggage carrier
6.3 Adjusting the Back Height
The backrest height can be adapted to the height of the
user.
Depending on anatomic back compensation, the backrest
moves down when bringing it in the upright position. In the
standing position the back strap should be tight.
1) Loosen the 4 screw connections on the back plate (see
fig. 4).
2) Slide the backrest up or down in the slotted holes.
3) Retighten the 4 screws.
®
241).
C1000 SF