Adjusting The Footplate - Otto Bock C1000 SF Instructions For Use Manual

Settings
3) Turn the supports to the inside or outside.
4) Retighten the two screws. The support must be fully
guided into the receiver.

6.7 Adjusting the footplate

The height and angle of the footplate can be adapted to the
requirements of the user.
The required footplate height depends on the lower leg
length of the user.
The angle of the footplate in the sitting position affects the
foot angle in the standing position.
Adjusting the height for the lower leg length
The height can be adjusted in two ways, either by moving
the footplate (a) or by moving the actuator (b).
a) Moving the footplate
1) Loosen and remove the mounting screws on both sides
of the footplate (see fig. 10, item 1).
2) Adjust the height of the footplate to the lower leg length
of the user (3 levels are possible).
3) Insert the mounting screws in the new position and
tighten them.
b) Moving the actuator
INFORMATION
If the distance from the footplate to the floor becomes too
small due to the adjustment described below, the installed
limit switch (see fig. 10, item 2) stops the standing function
20 | Ottobock
before the desired standing angle is reached. Extensive
mechanical conversion of the seat is required in order to
reach the desired standing angle again. Note that this type
of adjustment may therefore only be made by trained,
authorised, qualified personnel.
1) Loosen and remove the 2 Allen head screws holding the
actuator (see fig. 10, item 3).
2) Adjust the height of the footplate to the lower leg length
of the user (4 levels are possible).
3) Insert and tighten the Allen head screws at the new pos­
ition.
Fig. 10 Adjusting the lower leg length
C1000 SF