Preparing For Transport; Handing Over The Product; Maintenance And Repair; Disposal - Otto Bock C1000 SF Instructions For Use Manual

7.2.2 Preparing for transport

12

7.3 Handing over the product

WARNING
Lack of instruction
Tipping over, falling of the user due to lack of knowledge
► Instruct the user or the attendant in the proper use of the product when handing it over.
The following steps must be performed for the safe handover of the product:
• Have the user get into the product and perform a trial seat fitting. Pay special attention to proper positioning
according to medical considerations.
• The user and any attendants must be instructed in the safe use of the product. In particular, the enclosed
instructions for use (user) are to be used.
• The instructions for use (user) must be issued to the user or an attendant during handover of the wheelchair.
• The user or attendant should acknowledge that they have been instructed in how to use the product and were
informed of the residual risks.
• The user and all attendants definitely need to be advised that, when the power wheelchair is used in vehicles
for transporting persons with reduced mobility, the buckle tongues of the seat retaining straps must be connec­
ted to the buckles at the back of the seat.
• Depending on equipment: The supplied instructions for use for accessories have to be handed over in addi­
tion.

8 Maintenance and repair

The manufacturer recommends regular maintenance of the product every 12 months.
Further information on caring for the product and on maintenance/repair can be found in the instructions for use
(user).
Detailed information on repairs and programming/troubleshooting of the control device can be found in the service
manual.

9 Disposal

9.1 Disposal information

NOTICE
Disposal of batteries
Pollution due to incorrect disposal
► Observe the information printed on the batteries by the manufacturer.
► Note that the batteries may not be disposed of as household waste.
All components of the product must be disposed of properly in accordance with the respective national environ­
mental regulations.
C1000 SF
Transporting the power wheelchair
1) Drive the power wheelchair to its transport location
and position it.
INFORMATION: To lift or carry the power
wheelchair, use the eyebolts in the front and
back on the frame.
2) Switch off the control device (see instructions for
use (user)).
3) Verify brake locking. It should not be possible to
push the power wheelchair.
If necessary: Engage the brake (see instructions
for use (user)).
4) Use the eyebolts and cargo straps to attach the
power wheelchair to the transport vehicle (see
fig. 12, arrows).
Maintenance and repair
17