Omron NX-SID Series User Manual page 371

Event name SF_TwoHandControlTypeII Error
Meaning An error was detected in execution of a safety function block.
Source Depends on where the Sysmac Stu-
dio is connected and the system con-
figuration.
Error attributes Level
Effects User program
System-defined Variable
variables
None
Cause and Assumed cause
correction
Refer to information on the diagnostic
code that is given for attached infor-
mation 1 in the NX-series Safety Con-
trol Unit Instructions Reference
Manual (Cat. No. Z931).
Attached Attached information 1: Diagnostic code
information
Precautions/ None
Remarks
Event name SF_TwoHandControlTypeIII Error
Meaning An error was detected in execution of a safety function block.
Source Depends on where the Sysmac Stu-
dio is connected and the system con-
figuration.
Error attributes Level
Effects User program
System-defined Variable
variables
None
Cause and Assumed cause
correction
Refer to information on the diagnostic
code that is given for attached infor-
mation 1 in the NX-series Safety Con-
trol Unit Instructions Reference
Manual (Cat. No. Z931).
Attached Attached information 1: Diagnostic code
information
Precautions/ None
Remarks
NX-series Safety Control Unit User's Manual (Z930)
Source details
Minor fault Recovery
Continues. Operation
Data type
None
Correction
Implement the correction for the rele-
vant cause of the diagnostic code that
is given for attached information 1.
Source details
Minor fault Recovery
Continues. Operation
Data type
None
Correction
Implement the correction for the rele-
vant cause of the diagnostic code that
is given for attached information 1.
9 Troubleshooting
Event code 74AF 0000 hex
NX Unit Detection timing
Implement the Log category
correction.
The Unit continues to operate.
Name
None
Prevention
Program operation considering the
corrections that are given on the left.
Event code 74B0 0000 hex
NX Unit Detection timing
Implement the Log category
correction.
The Unit continues to operate.
Name
None
Prevention
Program operation considering the
corrections that are given on the left.
In DEBUG mode
(RUN) or RUN
mode
System
In DEBUG mode
(RUN) or RUN
mode
System
9
9 - 29