Rotax 912 i Series Maintenance Manual page 76

Figure 5.9: TYPICAL
Step
05–50–00
Page 10
September 01/2018
BRP-Rotax
MAINTENANCE MANUAL LINE
1 Allen screw M8
Procedure
10 Tighten 2 Allen screws M8x45and 8 Allen screws M6x45 with washers
6.4 diagonally from each other.
Tightening torque M6: 10 Nm (89 in.lb.)
Tightening torque M8: 25 Nm (18 ft.lb.)
11 Inspect the run-out.
See Maintenance Manual Heavy for the engine type 912 i Series Chapter
72-10-00 section Wear limits (CS24).
2 Allen screw M6
Effectivity: 912 i Series
Edition 2/Rev. 0