Rotax 912 i Series Maintenance Manual page 62

Points of Inspection
* no periodic maintenance require-
ment after the first 25 hours of
operation
Inspect all oil lines for damage, leak-
age, hardening from heat, porosity, se-
curity of connections and attachments.
Verify routing is free of kinks and
restrictions.
Inspect all fuel lines for damage, leak-
age, hardening from heat, porosity, se-
curity connections and attachments.
Verify routing is free of kinks and re-
strictions. Check steel fuel lines for any
cracks and/or scuffing marks.
Inspect the wiring (wiring harness) and
its connections for secure fit, damage
and signs of wear.
Inspect engine suspension and fasten-
ers (GENUINE ROTAX®) for secure fit,
including damage from heat, deforma-
tion, cracks.
Check the airbox (GENUINE ROTAX®)
incl. throttle body actuation. Inspect
sensors for tight fit, damage from heat,
damage and signs of wear.
Checking the air filter.
Inspection of the GENUINE ROTAX®
exhaust system included in the stand-
ard delivery.
NOTE
If there is no GENUINE ROTAX®
exhaust system in use, the specifi-
cations of the manufacturer must
be observed.
Drain oil from oil tank.
05–20–00
Page 12
September 01/2018
BRP-Rotax
MAINTENANCE MANUAL LINE
Interval Operating hours
25* 50 100
X X
X X
X
X X
X X
X X
X
8) Oil change
X X (5 X
Reference
200 600 1000
X X X 12–20–00
X X X 12–20–00
Checking the
X X X 12–20–00
X X X 12–20–00
Checking the
suspension
X X X
X X X 12–20–00
Cleaning the
dry air filter
X X X
X X X 12–20–00
Oil change,
Flushing the
Chapter Signa-
ture
Leakage
check
fuel lines
Check of
wiring
engine
oil circuit
Effectivity: 912 i Series
Edition 2/Rev. 0