Rotax 912 i Series Maintenance Manual page 107

Instruction To refill the coolant the following steps are necessary.
Step
Use only coolant as recommended in the current Operators Manual and SI-912 i-
Step
Figure 6.3: Coolant check/replenish TYPICAL
Effectivity: 912 i Series
Edition 2/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL LINE
Procedure
1
Open the radiator cap (1) on the expansion tank (2).
2 Check the coolant level. The coolant level must be filled up to the top (see
Sketch).
3 Inspect coolant with densimeter or glycol tester. Strongly discolored or
thickened coolant must be replaced.
001 "Selection of suitable operation fluids", current issue.
Procedure
4 If necessary, replenish with coolant of same composition.
5 Tighten the radiator cap by hand.
NOTE
The radiator cap must be tightened until the stop lug is contacted.
Radiator cap
1
ATTENTION
Expansion tank
2
12–10–00
Page 5
September 01/2018