Rotax 912 i Series Maintenance Manual page 73

Figure 5.6
Step
NOTE
Due to limited tolerances, it may be difficult to push the drive gear onto the end of
the crankshaft. If necessary, turn it and push it on in another position.
Step
Effectivity: 912 i Series
Edition 2/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL LINE
Crankshaft (power take off side)
1
3 Friction washer VS-30
Procedure
1 Push the drive gear onto the crankshaft.
Procedure
2
Secure the hex. nut M30x1.5 with LOCTITE 648 and screw it counter
clockwise left hand threads onto the crankshaft along with the friction
washer VS-30. Tightening torque 200 Nm (147 ft.lb.).
3 Inspect the run out.
Drive gear
2
4 Hex. nut
05–50–00
Page 7
September 01/2018