Introduction; Purpose Of The Design Guide; Additional Resources; Document And Software Version - Danfoss VLT DriveMotor FCP 106 Design Manual

Introduction

1 1
1 Introduction

1.1 Purpose of the Design Guide

This design guide for VLT
for:
•
Project and systems engineers.
•
Design consultants.
•
Application and product specialists.
The design guide provides technical information to
understand the capabilities of the drive for integration into
motor control and monitoring systems.
The purpose of the design guide is to provide design
considerations and planning data for integration of the
drive into a system. The design guide caters for selection
of drives and options for a diversity of applications and
installations.
Reviewing the detailed product information in the design
stage enables developing a well-conceived system with
optimal functionality and efficiency.
®
VLT is a registered trademark.

1.2 Additional Resources

Available literature:
•
®
VLT
information required to install and commission
the drive.
•
®
VLT
information required for integration of the drive
into a diversity of applications.
•
®
VLT
how to program the unit, including complete
parameter descriptions.
•
®
VLT
control panel (LCP).
•
®
VLT
operation pad (LOP).
•
®
VLT
DriveMotor FCP 106 BACnet Operating Instructions
for information required for controlling,
monitoring, and programming of the drive.
•
The VLT
provides information about installing and trouble-
shooting the PROFIBUS option.
•
The VLT
Guide provides information about configuring the
4
®
DriveMotor FCP 106 is intended
DriveMotor FCP 106 Operating Guide, for
DriveMotor FCP 106 Design Guide provides
DriveMotor FCP 106 Programming Guide, for
LCP Instruction, for operation of the local
LOP Instruction, for operation of the local
Modbus RTU Operating Instructions and VLT
®
PROFIBUS DP MCA 101 Installation Guide
®
PROFIBUS DP MCA 101 Programming
Danfoss A/S © 12/2018 All rights reserved.
®
VLT DriveMotor FCP 106
•
•
Technical literature and approvals are available online at
www.danfoss.com. Search for documentation.
Danfoss VLT
www.danfoss.com. Search for Energy Box.

1.3 Document and Software Version

This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the document version and the corresponding software
version.
In the drive, read the software version in
parameter 15-43 Software Version.
Edition
MG03M3xx
Table 1.1 Document and Software Version
1.4 Symbols, Abbreviations, Conventions,
and Glossary
The following symbols are used in this manual.
NOTICE
Indicates important information to be regarded with
attention to avoid mistakes or to avoid operating
equipment at less than optimal performance.
* Indicates default setting.
DIx
®
EMC
MM
MMP
PELV
PLC
Table 1.2 Abbreviations
system, controlling the drive, accessing the drive,
programming, and troubleshooting. It also
contains some typical application examples.
®
VLT Motion Control Tool MCT 10 enables configu-
ration of the drive from a Windows™-based PC
environment.
®
Danfoss VLT Energy Box software, for energy
calculation in HVAC applications.
®
Energy Box software is available at
Remarks
Software update.
Removed FCM 106 from manual.
DI1: Digital input 1.
DI2: Digital input 2.
Electromagnetic compatibility.
Memory module.
Memory module programmer.
Protective extra low voltage, low voltage with
isolation. For more information, see IEC
60364-4-41 or IEC 60204-1.
Programmable logic controller.
Software version
5.23
MG03M302