Ul Compliance; Software Version; Disposal Instructions; Safety - Danfoss VLT DriveMotor FCP 106 Design Manual

Introduction
The C-tick regulatory is about conducted and radiated
emission. For drives, apply the emission limits specified in
EN/IEC 61800-3.
A declaration of conformity can be provided on request.

1.5.4 UL Compliance

Illustration 1.3 UL Recognized
The drive complies with UL 508C thermal memory
retention requirements. For more information, refer to
chapter 3.5.6 Motor Thermal Protection.
1.5.5 Export Control Regulations
Drives can be subject to regional and/or national export
control regulations.
An ECCN number is used to classify all drives that are
subject to export control regulations.
The ECCN number is provided in the documents
accompanying the Drive.
In case of re-export, it is the responsibility of the exporter
to ensure compliance with the relevant export control
regulations.

1.6 Software Version

Read the software version of the drive in
parameter 15-43 Software Version.

1.7 Disposal Instructions

Equipment containing electrical components
must not be disposed of together with domestic
waste.
It must be separately collected with electrical
and electronic waste according to local and
currently valid legislation.

1.8 Safety

1.8.1 General Safety Principles

If handled improperly, drives have the potential for fatal
injury as they contain high voltage components. Only
qualified personnel are allowed to install and operate the
equipment. Do not attempt repair work without first
removing power from the drive and waiting the
MG03M302
Design Guide
designated amount of time for stored electrical energy to
dissipate.
Strict adherence to safety precautions and notices is
mandatory for safe operation of the drive.
Correct and reliable transport, storage, installation,
operation, and maintenance are required for the trouble-
free and safe operation of the drive. Only qualified
personnel are allowed to install and operate this
equipment.
Qualified personnel are defined as trained staff, who are
authorized to install, commission, and maintain equipment,
systems, and circuits in accordance with pertinent laws and
regulations. Also, the qualified personnel must be familiar
with the instructions and safety measures described in this
manual.
WARNING
HIGH VOLTAGE
Drives contain high voltage when connected to AC mains
input, DC supply, or load sharing. Failure to perform
installation, start-up, and maintenance by qualified
personnel can result in death or serious injury.
•
•
WARNING
UNINTENDED START
When the drive is connected to AC mains, DC supply, or
load sharing, the motor may start at any time.
Unintended start during programming, service, or repair
work can result in death, serious injury, or property
damage. The motor can start via an external switch, a
fieldbus command, an input reference signal from the
LCP, or after a cleared fault condition.
To prevent unintended motor start:
•
•
•
Danfoss A/S © 12/2018 All rights reserved.
Only qualified personnel must perform instal-
lation, start-up, and maintenance.
Before performing any service or repair work,
use an appropriate voltage measuring device to
make sure that there is no remaining voltage on
the drive.
Disconnect the drive from the mains.
Press [Off/Reset] on the LCP before
programming parameters.
Completely wire and assemble the drive, motor,
and any driven equipment before connecting
the drive to AC mains, DC supply, or load
sharing.
1 1
7