Copying A Configuration To Several Drives - Danfoss VLT DriveMotor FCP 106 Design Manual

Product Overview
Parameter list
Firmware
Motor database
.
.
.
Illustration 2.12 Data Transfer from PC to Memory Module
8. Repeat steps 6 and 7 for each memory module
needed with that particular configuration.
9. Place the memory modules in the drives.
2.2.3 Copying a Configuration to Several
Drives
It is possible to transfer the configuration of 1 VLT
DriveMotor FCP 106 to several others. It only requires a
drive that already has the wanted configuration.
1. Remove the lid from the drive with the configu-
ration to be copied.
2. Unplug the memory module.
3. Remove the lid from the drive to which the
configuration must be copied.
4. Plug in the memory module.
5. When copying is complete, plug-in an empty
memory module in the drive.
6. Place and tighten the lid.
7. Power cycle the drive.
8. Repeat steps 3–7 for each drive that is to receive
the configuration.
9. Place the memory module in the original drive.
10. Place and tighten the lid.
MG03M302
Design Guide
Copy motor
database
®
Danfoss A/S © 12/2018 All rights reserved.
2 2
15