Danfoss VLT DriveMotor FCP 106 Design Manual page 54

Specifications
Enclosure
1)
Overload
Typical shaft output [kW]
Typical shaft output [hp]
Maximum cable cross-section in terminals
(mains, motor)
[mm 2 /AWG]
Output current
40 °C (104 °F) ambient temperature
Continuous
(3x380–440 V) [A]
Intermittent
(3x380–440 V) [A]
6 6
Continuous
(3x440–480 V) [A]
Intermittent
(3x440–480 V) [A]
Maximum input current
Continuous
(3x380–440 V) [A]
Intermittent
(3x380–440 V) [A]
Continuous
(3x440–480 V) [A]
Intermittent
(3x440–480 V) [A]
Maximum mains fuses
Estimated power loss [W]
4)5)
Efficiency [%]
Table 6.6 Mains Supply 3x380–480 V AC Normal and High Overload: MH3 Enclosure
1) NO: Normal overload, 110% for 1 minute. HO: High overload, 160% for 1 minute. H7K5: 150% for 1 minute.
A drive intended for HO requires a corresponding motor rating. For example, Table 6.5 shows that a 1.5 kW motor for HO requires a N2K2 drive.
2) Maximum cable cross-section is the largest cable cross-section that can be attached to the terminals. Always observe national and local
regulations.
3) Applies to dimensioning of drive cooling. If the switching frequency is higher than the default setting, the power losses may increase. LCP and
typical control card power consumptions are included. For power loss data according to EN 50598-2, refer to www.danfoss.com and search for
ecoSmart.
4) Efficiency measured at nominal current. For energy efficiency class, see chapter 6.5 Ambient Conditions. For part load losses, see
www.danfoss.com and search for ecoSmart.
5) Measured using 4 m (13.1 ft) shielded motor cables at rated load and rated frequency.
52
®
VLT DriveMotor FCP 106
2)
3)
Danfoss A/S © 12/2018 All rights reserved.
N5K5
NO HO
5.5
7.5
4/12
12
13.2 19.2
11
12.1 17.6
11
12 17
9.4
10 15
See chapter 6.8 Fuse and Circuit Breaker Specifications.
201
0.97
MH3
N7K5
NO
7.5
10
4/12
15.5
17.1
14
15.4
15
17
13
14
252
0.97
H7K5
HO
23.3
21
23
19
MG03M302