Cisco ASA Series Cli Configuration Manual page 1242

Configuration Examples for the Phone Proxy
Step 3
Create the CTL file instance on the new ASA using the same name as the one used in the SAST
trustpoints created in
UMC (primary and secondary).
hostname(config)# ctl-file ctl_name
hostname(config-ctl-file)# record-entry cucm trustpoint trust_point address address
hostname(config-ctl-file)# record-entry capf trustpoint trust_point address address
hostname(config-ctl-file)# no shutdown
Configuration Examples for the Phone Proxy
This section includes the following topics:
•
•
•
•
•
•
Example 1: Nonsecure Cisco UCM cluster, Cisco UCM and TFTP Server
on Publisher
Figure 1-2
following topology.
Cisco ASA Series CLI Configuration Guide
1-44
mGF/hfDDNAICBAA=
hostname(config)# quit
INFO: Import PKCS12 operation completed successfully
hostname(config)#
Step 2 by entering the following commands. Create trustpoints for each Cisco
Example 1: Nonsecure Cisco UCM cluster, Cisco UCM and TFTP Server on Publisher, page 1-44
Example 2: Mixed-mode Cisco UCM cluster, Cisco UCM and TFTP Server on Publisher, page 1-46
Example 3: Mixed-mode Cisco UCM cluster, Cisco UCM and TFTP Server on Different Servers,
page 1-47
Example 4: Mixed-mode Cisco UCM cluster, Primary Cisco UCM, Secondary and TFTP Server on
Different Servers, page 1-48
Example 5: LSC Provisioning in Mixed-mode Cisco UCM cluster; Cisco UCM and TFTP Server on
Publisher, page 1-50
Example 6: VLAN Transversal, page 1-52
shows an example of the configuration for a non-secure Cisco UCM cluster using the
Chapter 1 Configuring the Cisco Phone Proxy