Setting Of Trim Down Position Limit - Suzuki DF70A Service Manual

Setting of Trim Down Position Limit

Once the ECM has been replaced or the trim sensor
removed and reinstalled, the resetting of the trim lower
position limit should be performed.
Perform this set-up after the current position setting has
been cancelled, as explained in the following
procedures.
Canceling Trim Down Position Limit Setting
1) Turn the ignition key to the "ON" position.
2) Pull out the emergency stop switch lock plate.
3) Make sure that remote control handle is in "Neutral".
(Check that the neutral switch is in the "ON"
position.)
4) Top mount type:
Using the throttle only function of the remote control
box, move the control handle forward until the
caution buzzer sounds one time.
Side mount type:
Using the throttle only function of the remote control
box, move the warm-up lever upward until the
caution buzzer sounds one time.
"NEUTRAL"
Z9J0112206003
I9J011220054-01
"NEUTRAL"
I9J011220055-01
5) Press the "DOWN" side of the PTT switch for three
seconds and the buzzer will sound two times briefly
indicating the setting has been canceled.
DOWN
1. PTT switch
6) Return the throttle to the fully closed position.
Setting Trim Down Position Limit
1) Press the "DOWN" side of the PTT switch so that the
full trim down position is obtained.
2) Turn the ignition key to the "ON" position.
3) Pull out the emergency stop switch lock plate.
4) Make sure that remote control handle is in "Neutral".
(Check that the neutral switch is in the "ON"
position.)
5) Top mount type:
Using the throttle only function of the remote control
box, move the control handle forward until the
caution buzzer sounds one time verifying the set
mode is active.
Side mount type:
Using the throttle only function of the remote control
box, move the warm-up lever upward until the
caution buzzer sounds one time verifying the set
mode is active.
6) Press the "DOWN" side of the PTT switch three
times within three seconds. The buzzer will sound
one time briefly indicating the setting has been
accepted.
7) With the throttle fully closed, install the lock plate on
the emergency switch.
Press the "UP" side of the PTT switch to obtain the
full tilt up position and then press the "DOWN" switch
to obtain the full trim down position. Check that the
positions are set.
Power Trim and Tilt: 2B-11
1
I9J011220056-03