Lower Side Cover Removal and Installation
Removal
1) Remove the side cover rubber (1).
1
2) Remove ten screws (2) and STBD side cover (3).
Z9J0112106002
I9J011210009-01
2
3
I9J011210007-02
3) Remove three screws (4) and PORT side cover (5).
4
5
4) Disconnect PTT switch lead connector.
Installation
Installation is reverse order of removal with special
attention to the following step.
• Tighten side cover screws, pre-coated with thread
lock, to specified torque.
Tightening torque
Side cover screw: 7 N·m (0.7 kgf-m, 5 lbf-ft)
Housing and Bracket:
I9J011210008-02
I9J011210010-01
2A-3