Driveshaft Upper Oil Seal Replacement; Driven Gear Bearing And Oil Seal Replacement - Suzuki DF70A Service Manual

2A-16 Housing and Bracket:

Driveshaft Upper Oil Seal Replacement

1) Remove the engine holder. Refer to "Engine Holder /
Oil Pan / Driveshaft Housing / Mounts Disassembly"
(Page 2A-6).
2) Extract oil seals with oil seal remover.
Special tool
(A): 09913–50121 (Oil seal remover)
3) Apply water resistant grease to outer circumference
of oil seal.
4) Drive the two oil seals (one at a time) into the engine
holder.
NOTE
Install oil seal with lip (spring side) facing
downward (oil pan side).
: Grease 99000–25161 (SUZUKI Water
Resistant Grease (250 g))
5) Reassemble the engine holder. Refer to "Engine
Holder / Oil Pan / Driveshaft Housing / Mounts
Assembly" (Page 2A-9).

Driven Gear Bearing and Oil Seal Replacement

1) Remove the engine holder. Refer to "Engine Holder /
Oil Pan / Driveshaft Housing / Mounts Disassembly"
(Page 2A-6).
2) Remove bearing (1) with special tool and sliding
hammer.
Z9J0112106008
(A)
I9J011210076-01
I9J011210121-01
Z9J0112106009
CAUTION
Do not re-use the bearing once removed.
Always use a new bearing.
Special tool
(A): 09941–64511 (Bearing remover)
(B): 09930–30104 (Sliding hammer)
3) Extract oil seal (2) with oil seal remover.
Special tool
(C): 09913–50121 (Oil seal remover)
4) Apply water resistant grease to outer circumference
of oil seal.
5) Drive the oil seal into the engine holder.
NOTE
Install oil seal with lip (spring side) facing
upward (Driven gear bearing side).
: Grease 99000–25161 (SUZUKI Water
Resistant Grease (250 g))
(A)
1
(B)
I9J011210078-01
(C)
2
I9J011210079-01
I9J011210081-01