Engine Holder / Oil Pan / Driveshaft Housing / Mounts Assembly - Suzuki DF70A Service Manual

21) Remove two bolts and oil strainer (32).
22) Remove the oil relief valve (33) and gasket.
Engine Holder / Oil Pan / Driveshaft Housing /
Mounts Assembly
Assembly is in reverse order of disassembly with special
attention to the following steps.
Engine Holder to Oil Pan
• Install the gasket (1) and oil relief valve (2) to the
engine holder, then tighten the valve securely.
Tightening torque
Oil relief valve (a): 27 N·m (2.7 kgf-m, 19.5 lbf-ft)
• Apply engine oil to O-rings (3), then install O-rings to
oil strainer (4).
32
I9J011210035-01
33
I9J011210036-02
Z9J0112106005
2
(a)
1
I9J011210037-01
• Install oil strainer to engine holder, then tighten bolts
securely.
4
3
• Install two dowel pins (5) and gasket (6) to oil pan.
CAUTION
Do not reuse gasket. Always assemble with a
new gasket.
5
• Install engine holder (7) to oil pan (8), then securely
tighten it with engine holder bolts (9).
7
8
7
8
Housing and Bracket:
4
I9J011210038-01
6
5
I9J011210039-03
9
I9J011210040-01
9
I9J011210041-02
2A-9