Ex. Manifold Temp. Sensor Removal And Installation; Ex. Manifold Temp. Sensor Inspection - Suzuki DF70A Service Manual

Ex. Manifold Temp. Sensor Removal and
Installation
Removal
1) Disconnect the Ex. manifold temp. sensor lead wire
connector.
2) Loosen and remove the Ex. manifold temp. sensor
(1).
Installation
Installation is reverse order of removal.
• Clean mating surface of sensor and exhaust cover.
• Tighten sensor to specified torque.
Tightening torque
Ex. manifold temp. sensor (a): 8 N·m (0.8 kgf-m,
5.8 lbf-ft)
• Connect connector to sensor securely.

Ex. Manifold Temp. Sensor Inspection

Z9J0111306004
1
I9J011130041-01
(a)
I9J011130042-01
Engine Electrical Devices:
1) Remove the Ex. manifold temp. sensor.
Refer to "Ex. Manifold Temp. Sensor Removal and
Installation" (Page 1C-9).
2) Immerse temperature sensing part of Ex. manifold
temp. sensor in water.
3) Measure resistance between sensor terminals while
heating water gradually.
4) If measured resistance does not change in the
proportion indicated, replace sensor.
Ex. manifold temp. sensor specification
Water
temperature: 0 (32)
°C (°F)
Resistance
5.3 – 6.6 1.8 – 2.3
(kΩ)
1
1. Thermometer
5) Reinstall the Ex. manifold temp. sensor.
Refer to "Ex. Manifold Temp. Sensor Removal and
Installation" (Page 1C-9).
1C-9
Z9J0111306005
25 (77) 50 (122) 75 (135)
0.73 – 0.33 –
0.96 0.45
2
I9J011130051-01
2. Heater
Temperature
I9J011130008-02