Propeller Removal And Installation - Suzuki DF70A Service Manual

3A-4 Right Hand Rotation Unit:

Propeller Removal and Installation

WARNING
!
• When installing or removing the propeller,
shift into "Neutral" and remove the
emergency stop switch lock plate so that
the motor cannot be started accidentally.
• To prevent injury from propeller blades,
wear gloves and place a block of wood
between the anti-cavitation plate and the
propeller blade tips to lock the propeller in
place before attempting to remove or
install propeller nut.
Removal
1) Shift to "Neutral" position.
2) Remove cotter pin (1) from propeller nut and remove
propeller nut (2).
3) Remove washer (3), spacer (4), propeller (5) and
stopper (6) from the propeller shaft.
5
6
Z9J0113106002
I9J011310001-01
4
1
2
3
I9J011310002-02
Installation
1) Coat the propeller shaft splines liberally with Suzuki
water resistant grease.
: Grease 99000–25161 (SUZUKI Water
Resistant Grease (250 g))
2) Install propeller stopper (1) onto propeller shaft, then
slide on the propeller (2).
3) Fit spacer (3), washer (4) and nut (5), then tighten
nut to specified torque.
4) Push cotter pin (6) through nut and shaft, then bend
to secure.
Tightening torque
Propeller nut (a): 55 N·m (5.5 kgf-m, 40.0 lbf-ft)
2
1
3
6
5
4
I9J011310017-01
(a)
I9J011310003-04