Driveshaft Oil Seal Replacement; Lower Unit Assembly - Suzuki DF70A Service Manual

3A-16 Right Hand Rotation Unit:

Driveshaft Oil Seal Replacement

1) Remove the driveshaft oil seal housing. Refer to
"Lower Unit Disassembly" (Page 3A-8).
2) Using special tool, remove two oil seals out of the
driveshaft oil seal housing.
Special tool
(A): 09913–50121 (Oil seal remover)
3) Apply water resistant grease to inner circumference
of driveshaft oil seal housing.
: Grease 99000–25161 (SUZUKI Water
Resistant Grease (250 g))
4) Grease the inner lips of oil seal.
With the lips facing away from driveshaft bearing,
place seal in position and drive it into the oil seal
housing.
5) Assemble the driveshaft oil seal housing. Refer to
"Lower Unit Assembly" (Page 3A-16).
Z9J0113106026
(A)
I9J011310073-01
Direction of
water pump case
I9J011310074-02

Lower Unit Assembly

Assembly is in reverse order of disassembly with special
attention to the following steps.
CAUTION
• Make sure that all parts used in assembly
are clean and lubricated.
• It is recommended that all seals, gaskets
and O-rings be replaced with new on
assembly.
• After assembly, check parts for tightness
and smoothness of operation.
• Before final assembly, be absolutely
certain that all gear contact, shim
adjustments and tolerances are correct.
Failure to correctly adjust these areas will
result in lower unit damage. Refer to
"Lower Unit Gears - Shimming and
Adjustment" (Page 3A-24).
Forward Gear
Place the forward gear back-up shim (1), forward gear
bearing outer race (2) in position, then install forward
gear (3) with forward gear bearing (4).
3
Z9J0113106027
1
2
I9J011310075-01
4
I9J011310076-01