Remote Control Box Position - Suzuki DF350A Setup Manual

REMOTE CONTROL BOX POSITION


Installing the remote control box in an inap-
propriate location can result in operating
difficulties and an accident.
Be sure to install the remote control box in
a location that makes it convenient for the
operator to use the control lever.

Open, short circuit or poor electrical con-
nections can result in loss of electronic
throttle and gear shift control.
Be sure to take the following precautions:
• Do not cut or extend the wiring harness
and lead wires of the remote control box.
Water may enter from the joint of the wir-
ing harness or lead wire, causing a conti-
nuity error at the connections, resulting
in shifting and throttle control errors.
• Use a waterproof cap to seal the connec-
tors not in use.
Set the Remote Control Box in a position in which it
does not obstruct the operations of the control lever
and switches. Make sure there is no obstruction on
the path of the remote control wire harness.
Allow a space so that the bottom of the Remote
Control Box does not contact any other parts.
Provide a space so that the remote control wire har-
ness can be routed without vending sharply.
Minimum 50 mm
(2 in )
Obstruction
19