Re Set Active Display Mode; Ro Read Pwok Output Status - Newport LDS1000 User Manual

LDS1000
10.5.07
Related commands
10.5.08
Related commands
RE
Use MNL
Syntax RE
Parameter
Description
Response
Error D
Example RE
RD
TB
TE
RO
Use MNL
Syntax RO
Parameter
Description
Response ROnn
Errors D
S
Example RO
RO0
The PWOK output is in status 1 if the sensor receives a sufficient quanti-
ty of light to carry out the measurement.
This logical output is available on the rear panel of the LDS1000 Controller.
TB
TE
Controller for Laser Diode Sensors
Set Active Display Mode
RMT ACT
None.
Enable display in remote mode. The response times related to
display refresh may appear.
None.
Execution not allowed.
| Active display.
Frozen display.
Read error.
Read error code.
Read PWOK Output Status
RMT ACT
None.
Read the status of the PWOK output. The return value will be
equal to 0 or 1 depending on whether the interface is in high or
low status.
nn = status of the PWOK output.
Execution not allowed.
Communication time-out.
| Request status of TRIGG input.
| The PWOK output is in low status.
Read error.
Read error code.
45
NOTE
EDH0170FE1010 – 09/98