Starting The Equipment; Setting Up; Mounting; Electric Connections - Newport LDS1000 User Manual

LDS1000
5.0

Starting the Equipment

EDH0170FE1010 – 09/98
5.1

Setting Up

The setting up of the sensor is explained in each user's manual of the LDS
instruments.
You are advised to read the user's manuals corresponding to each sensor
delivered. They contain important information for optimal use of the ins-
truments. These instructions can vary from one sensor to another.
5.1.1

Mounting

Small movement measurements require specific precautions as far as the
quality of the mounting of the equipment is concerned. It is particularly
important to make sure that the sensor, the reflector and their correspon-
ding supports are solid
5.2

Electric Connections

Before connecting check that all equipment is switched off.
Do not use any cable other than the one supplied by NEWPORT.
The cable provided connects the sensor to the electronic controller. The
male part should be connected to the optical head, the female part to the
controller. Please ensure that all connections are correctly screwed in.
The cable is available in two standard lengths:
Cable for LDS1000, length 5 meters
Cable for LDS1000, length 10 meters
For longer lengths, please consult us.
A lead ensures the connection to the mains supply on a switch and fuse
base.
The controller is equipped with a self-selecting input voltage power supply
(from 90 V to 250 V).
Set the switch to "0" (OFF) position.
Controller for Laser Diode Sensors
RECOMMANDATION
CAUTION
CAUTION
10
LDS1000-OPT01NN
LDS1000-OPT02NN