Newport LDS1000 User Manual page 76

LDS1000
Warnings
CERTAIN SAFETY PRECAUTIONS MUST BE RESPECTED BEFORE ANY
INTERVENTION ON THE LDS1000 CONTROLLER.
IN ORDER TO COMPLY WITH SAFETY STANDARDS CONCERNING THE
USE OF THIS EQUIPMENT, THE USER MUST TAKE THE FOLLOWING PRE-
CAUTIONS AND RESPECT THE WARNINGS THAT APPEAR LATER IN
THIS MANUAL.
LDS1000 is a PIECE OF EQUIPMENT DESIGNED TO BE CONNECTED BY A
NON INDUSTRIAL PLUG:
• User safety is ensured by grounding the equipment.
• The user must check the conformity of his electrical installation
• The equipment must be connected to the power supply with a CEE22-
type cable that complies with the EN60950 standard.
Contact your electrician to check the connections of your plugs.
All the sockets that are near your equipment must be equipped with a
ground connection.
Any break in the ground connection can lead to an electric discharge.
WARNING: CONNECTING ADDITIONAL EQUIPMENT
Additional equipment can be connected to the LDS1000 Controller (com-
puter, oscilloscope, etc.).
The connection cables carry VERY LOW VOLTAGE.
The user must make sure that the equipment connected and the cables
used comply with EC standards.
WARNING: LDS SERIES SENSOR
The user must read the warnings in the LDS sensor manual before setting
up the equipment.
The sensor must be connected to the LDS1000 Controller using a cable
supplied by us and that has not been modified.
Connection and disconnection must never be carried out to equipment
that is switched on.
vii
Controller for Laser Diode Sensors
WARNING: GROUNDING
EDH0170FE1010 – 09/98